air inlet的例句大全

The higher Do , lower inlet velocity and lower fresh air radio lead to higher TVOC dose.

较大的初始扩散系数 、 较小的进口风速和新风混合比会导致较高的TVOC剂量.

In order to let high octane number natural gas to be compression ignited, measures like high compression ratio, glow plug heating, heat-isolating coating, as well as air inlet heating, are adopted in this system.

为了使高辛烷值的天然气实现压缩着火，该系统采用了高压缩比、电热塞助燃和燃烧室壁面喷涂隔热层等技术措施，并采用了进气预热。

Otherwise, the air exhauster is not necessary, and the air inlet ( 4) connecting with the high-pressure clean air is arranged in the air inlet pipeline.

或不用抽气机，而在进气管道有一接高压清洁空气的进气口（4）。

Requirement: Air inlet must start to open when down stream pressure is 1.0 PSI or above.

要求: 当下游流体压力在1.0PSI及以上时,空气进口必须开始打开.

Therefore, by lowering the temperature of inlet air power and efficiency of gas turbine generators.

本文简要的从热力学角度分析其原因, 同时介绍降低燃气轮机空气进口温度的方法.

The air pressure at the hot value inlet does not become excessively low.

在热风阀进口处的风压不要变得太低.

Through lowering the air inlet total pressure, reducing the compression angle of air, increasing the nozzle length, cutting down the nozzle radius and the axial gap of electrode, the arc ignition energy can be improved.

通过减小流动压差、缩小空气压缩角、增加喷孔长度、减小喷孔半径以及减小轴向间隙等可以有效提高电弧的点火能量。

The utility model relates to a pneumatic injection pump, comprising a cover board, a vessel, an air inlet, compressed air, mortar and a grout outlet.

气压式注浆泵主要由盖板、容器、进气口、压缩空气、砂浆和出浆口组成。

At the same time air is sucked into the inlet to replace the exhausted air.

同时,外面空气由进气口吸入代替被排出的空气.

In comparison with 30 ° air inlet, the generated vortexes are fewer, weaker and nearer to the air inlets when the inlet angle is 45 ° along the axial cross section.

与30°进气道相比，沿轴向横截面上45°进气道所形成的回流区向进气道一侧偏移，回流区区域减少，强度减弱。

Sugar cane solution is used as a trial solution in experiment. An evaporative capacity of impinging-stream concentrator is studied by changing inlet air temperature, and the ratio of inlet sugar solution flow rate to inlet gas flow rate and the length of accelerating pipe.

采用蔗糖水溶液作为试验溶液，通过改变空气进口温度、液气质量流量之比、液滴加速管的长度等对撞击流浓缩器（ISC）的蒸发能力进行了研究。